This is a deal for the early adapters. The Atmomixani Striker RDA has been cloned and this is the first place to get one. The price is very reasonable for a US shop with quick shipping. For a nice low price you get a stylish RDA with all the options. Once again we revisit the 3 post RDA looking for significant improvements over the plethora of options available.
I know a lot of people think the Striker is Atmomixani’s clone of the omega, but it has its own significant changes. The lip on the drip dish is not as high. This provides some benefits even though it won’t hold as much e-liquid. The post heights are slightly staggered as well. A good point to notice about this clone is that dual AFC are stock. Sometimes early clone models have air flow control systems that make no sense, but this RDA offers dual 1.5 mm holes opposite of each other for a nice dual coil (or quad) set up. Details on this RDA were not ambiguous and they clearly state a copper 510 connector pin.
There are some design choices that make the Striker RDA (clone) a nice dripper. The most noticeable is the curved negative posts. Those same posts have a nice fat diameter for coil wrapping. I know a lot of mods have drilled posts for mounting coils, but I’ve always had better luck with screw wrapping than I’ve had with drilled posts. I guess it’s a personal preference, but my leads seem to always get snapped off when dealing with drilled posts. Another point is the Phillips head screws, most multi tools have a Phillips head screwdriver, but I hate carrying around an Allen wrench for a particular atomizer.
RDA fans will definitely appreciate this atomizer. The impressions on the top cap indicate where the air flow holes are. I wish more RDA’s used that.
Get yours here: http://www.vaperoyalty.com/hcigar-striker-rda/